Description
For Sale: 2.3L Millington Diamond Turbo Race/Rally engine
Brand new Build – aside from one brief Dyno Run a 20 minute quali and ten minutes of racing.
Specification:
Millington Diamond Turbo Block / Sump bored and Honed to suit Omega Turbo pistons and Line Bored by Roy at Millington’s following supply of a new block, but not the MB Cage / sump, hence the line-bore). Block is the “sump to head” bolt (EN40) turbo design that clamps the Head/Block/Main Bearings together enabling higher clamping forces for turbo applications.
Note: Current clamping bolts enable up to 1.9 BAR boost which is good for around 650 BHP/470 ft/lbs.
Also available are a brand new set of TK Precision rolled thread through bolts to F1 spec and tailor made to suit this engine which would facilitate boost well over 3 BAR.
Smith & Jones Brand new Turbo head/valves/springs as above (Roy wasn’t producing any more Turbo heads at the time).
GpA Oil squirters!
Millington Turbo cams. (Roy would not divulge spec, save for the installation timing figures).
Julian Godfrey gas-filled wills rings head gasket.
Julian Godfrey spec Rallycross EN24 H-Beam conrods.
Millington / Omega Turbo pistons with heavy duty gudgeon pins.
Lightweight Millington small Flywheel
Genuine RS500 8 injector plenum/Throttle body with 8 Grey injectors – matched to head
Garrett GT3582 Turbo.
PACE Dry sump oil Pump.
Millington / Arc Starter/Alternator
MoTeC M800 ECU with Laptop and MoTeC E888 expander module to enable additional sensors etc. if desired.
Several M800 configuration maps for this engine. But note: The M800 can easily switch from Dry/Quali/Rain/Damp Maps on the hoof.
Honda individual coil per cyl ignition.
Milspec “Starter” Loom to suit Honda coils. Note: Needs additional connexion O/P’s if additional sensors as desired.
Note: This motor is one of a limited series of Millington Turbo Engines built for the ALMS championship in America and subsequently produced in limited batches for UK customers. This particular engine though has stronger and a number of more up-to-date components as detailed above.



